Speed Adjusting Dial; Switch Action - Makita GRJ02 Manual De Instrucciones

Speed adjusting dial

1
Fig.4
► 1. Speed adjusting dial
The strokes per minute can be adjusted just by turning
the speed adjusting dial. This can be done even while
the tool is running. The dial is marked 1 (lowest speed)
to 5 (full speed). Turn the speed adjusting dial between
1 and 5 according to your work.
Refer to the table to select the proper speed for the
workpiece to be cut. However, the appropriate appli-
cation may differ with the shape and hardness of the
workpiece. In general, orbital cutting action is suitable
for soft materials.
NOTE: Orbital cutting action is suitable for most soft
materials such as wood, however, sometimes not,
according to the shape or the hardness of the work-
piece, etc.
Number on adjusting dial
5
4
3
2
1
Workpiece to be cut
Wood
Autoclaved lightweight
concrete
Iron pipes, cast iron pipes and
aluminum
Plastics
Stainless steel
NOTE: If the tool is operated continuously at low
speeds for a long period of time, the operation life of
the motor will be reduced.
NOTE: The speed adjusting dial can be turned only
as far as 5 and back to 1. Do not force it past 5 or 1,
or the speed adjusting function may no longer work.
Strokes per minute
3,000
2,500
2,000
1,500
1,000
Number on adjusting dial
5
4 - 5
2 - 4
1 - 3
1 - 2

Switch action

CAUTION:
Before installing the battery car-
tridge into the tool, always check to see that the
switch trigger actuates properly and returns to
the "OFF" position when released.
CAUTION:
When not operating the tool,
depress the lock-off button from A side to lock the
switch trigger in the OFF position.
2
B
1
Fig.5
► 1. Switch trigger 2. Lock-off button
To prevent the switch trigger from accidentally pulled,
the lock-off button is provided.
To start the tool, depress the lock-off button from B side
and pull the switch trigger.
Tool speed is increased by increasing pressure on the
switch trigger. Release the switch trigger to stop. After
use, always press in the lock-off button from A side.
Lighting up the front lamp
1
Fig.6
► 1. Lamp
CAUTION:
Do not look in the light or see the
source of light directly.
Pull the switch trigger to light up the lamp. The lamp
keeps on lighting while the switch trigger is being pulled.
The lamp goes out approximately 10 seconds after
releasing the switch trigger.
7 ENGLISH
2
A
1