Installation Of Propass Conveyor And Swivel Kit; Figure 15: Locking Clamps For Vortex Brush; Figure 16: Install Doublers Onto Propass; Figure 17: Lift The Swivel Into Position On Propass - TYCROP ProPass 180 Top Dresser Manual Del Operador

Figure 15: Locking clamps for Vortex Brush

6. Install the safety pins on the Twin Spinner option.
7. Connect the option's hydraulic couplers to the
ProPass hydraulic couplers.
Installation of ProPass Conveyor and
Swivel Kit
Before installing the Cross Conveyor to the ProPass Base
Model, the Side Rail Doublers must be installed on the
Base Model. Using the bolts currently installed in the
ProPass Base Model Scraper (arrows), install the left and
right side Doublers (see Figure 16). Ensure the scraper
remains in contact with the belt.

Figure 16: Install doublers onto ProPass

1. Remove the Swivel and Conveyor from the crate.
Page 16
All manuals and user guides at all-guides.com
TYCROP Manufacturing Ltd. ProPass 180 Top Dresser Operator's Manual
2. Leaving the Conveyor attached to the Swivel and
with the aid of an assistant, lift the Swivel into
position and align the plastic bearing locations
with the mounting brackets (see Figure 17
arrows).

Figure 17: Lift the swivel into position on ProPass

3. Clamp the Swivel to the ProPass using the Quick
Attach Latches. If the Latches are not snug when
clamping, loosen the two ¼" (6.35mm) bolts on
the Latches and adjust them until the Latches
clamp tight enough to keep the Swivel from
moving on the ProPass (see Figure 18).

Figure 18: Clamp the swivel to the ProPass

4. Check the clearance of the Adjustable Belt Guard
to the ProPass main conveyor belt. If the gap
between the belt and the Adjustable guard (Figure
Setup Instructions