Maintenance Instructions; Warranty; Safety Checks; Tires And Wheels - TYCROP ProPass 180 Top Dresser Manual Del Operador

Maintenance Instructions

When it comes to maintenance, an authorized TYCROP
Distributor knows the ProPass 180 Top Dresser best. The
Distributor can help you, by explaining how to use the
ProPass, to improve the quality of your turf maintenance.
: Disconnect all power sources
W
ARNING
to the ProPass before doing maintenance
work.

Warranty

The warranty and registration is supplied as a separate
form. Ensure that you complete this form and return it to
an authorized TYCROP Distributor within 30 days of
purchase.

Safety Checks

At the start of each day, complete these safety checks
before operating the ProPass. Report any safety problems
to an authorized TYCROP Distributor and your supervisor.
See the Safety Instructions in this manual for details.
Note: Photocopy these pages and use them as a regular
safety checklist.

Tires and Wheels

‪
The recommended tire pressure is 69 kPa (10 psi), or
as recommended by the tire manufacturer.
‪
Check for excessive wear or visible damage.
‪
Check that the wheel bolts are tight and none are
missing.

Rear Gate

‪
Check that the adjustable section of the rear gate
opens and closes without sticking.

Jack Stands

‪
Safely stow the jack stand(s) in the up position before
traveling. On TYCROP direct connect chassis stow
the jack stands on the rear of the machine.
Maintenance Instructions
All manuals and user guides at all-guides.com
TYCROP Manufacturing Ltd. ProPass 180 Top Dresser Operator's Manual
‪
Check that the hitch pin and jack stand are not
damaged, and the safety pin is in place. (Replace
safety pins if missing or damaged).
‪
Check that the hitch conections are not loose. (If so,
install a spacer between the hitch connections).

Hydraulic System

‪
Check the hydraulic system for oil leaks. If you find a
leak, tighten the fitting, or replace or repair the
damaged part.
‪
Check the hydraulic hoses for wear or visible damage.
‪
Check the hydraulic oil level. Fill up if necessary.
: If the hydraulic lines are not
C
AUTION
properly connected, they may come apart
during use. To test the connection, try to
pull it apart.

Conveyor Belt and Rollers

‪
Check that the conveyor belt is tracking straight on the
rollers and does not slip. Make adjustments if
necessary. See the Conveyor Belt Tracking Procedure
in this manual.
‪
Check the front and rear roller bearings every two
months for wear or visible damage.
‪
Check the condition and tension of the drive chain and
the sprockets.
: Check for trapped spreading material
I
MPORTANT
between conveyor bed, belt, and rollers. See How to
Wash the ProPass in this manual.

Belt and Rear Gate Seals

‪
Check all rubber seals for wear or damage. Replace or
repair the seals if any leakage occurs.
‪
Check and adjust the conveyor belt cleaning scraper.
Ensure the scraper is in full contact with the belt
across its length.
Page 33