Flow Control Valve For Option; On/Off Pendant; How To Operate The Controls And Options On Eh Models; Control Pendant Legend - TYCROP ProPass 180 Top Dresser Manual Del Operador

flow control valve to the highest setting of 10. To stop the
conveyor belt, set it to the lowest setting.

Flow Control Valve for Option

A hydraulic flow control valve controls the speed of the
option (Vortex Brush or Twin Spinner). The highest
speed setting is 10. Use a lower setting for applications
that require slower speeds.
: Do not leave the ProPass
W
ARNING
unattended while it is running.

On/Off Pendant

Use the two switches on the on/off pendant to run the
conveyor belt or the option (Figure 28). The on/off
pendant is kept within reach of the operator.
Figure 28: On/off pendant
How to Operate the Controls and
Options on EH Models
: Before operating the
W
ARNING
ProPass, read and understand the entire
Operator's Manual and all safety decals.
Operating Instructions
All manuals and user guides at all-guides.com
TYCROP Manufacturing Ltd. ProPass 180 Top Dresser Operator's Manual
Figure 14: Control Pendant For EH Models

Control Pendant Legend

Floor Speed
Option Speed
Preset Setting
Not Used
Option start followed by belt start
Page 23