How To Operate The Propass With The 11Hp Hydraulic Power Pack - TYCROP ProPass 180 Top Dresser Manual Del Operador

: Never leave the pendant on when the
I
MPORTANT
ProPass is not in use. Otherwise, the tow vehicle's
battery may discharge.
How to Operate the ProPass with the
11HP Hydraulic Power Pack
The Honda engine for your ProPass conforms to all U.S.
Environmental Protection Agency regulations relating to
non-road engines under the Clean Air Act.
Before starting the Honda engine, read the engine
owner's manual.
6. Check that the oil drain port is tight and
completely fill the hydraulic tank with ISO VG-
68 hydraulic fluid—about 32.9 L (8.7 U.S. gal).
See the chart in this manual for recommended
hydraulic fluids.
: The hydraulic system will not
I
MPORTANT
completely fill with fluid until the system is powered
up. The hydraulic fluid must therefore be checked and
topped up after initial running.
7. Connect the clevis hitch of the ProPass to the
tow vehicle. Use a high-strength hitch pin
approved for tow vehicles.
Page 26
All manuals and user guides at all-guides.com
TYCROP Manufacturing Ltd. ProPass 180 Top Dresser Operator's Manual
8. Check the engine's oil level and fill if required.
See the engine owner's manual.
9. Fill the fuel tank. Use unleaded fuel with an
octane rating no less than 87.
: Ensure that the on/off
C
AUTION
pendant is in the off position on SH
models and the control pendant is off on
EH models.
10. Turn on the fuel valve, place the throttle lever at
half throttle, engage the choke, and start the
engine. Once engine starts turn off choke and
increase throttle to max.
11. Test the ProPass operation. Ensure that there are
no hydraulic leaks and make any adjustments
needed.
12. After testing the hydraulic system, check the
hydraulic fluid and add more if required.
13. Place the on/off pendant for SH models or
control pendant for EH models within reach of
the driver's seat.
14. Refer to "How to Operate the ProPass".
: Ensure that the pendant and any cords
I
MPORTANT
do not drag on the ground during operation.
Operating Instructions