Care And Maintenance; Troubleshooting - Rothenberger SUPERTRONIC 2000 E Instrucciones De Uso

Battery pack is not charged. Temperature too high/ too low. When the temperature of the battery
pack is between 0 °C and 50 °C / 32° - 122° F, the charging process begins automatically.
● Warning display (4) flashes.
Battery pack is defective. Remove the battery pack immediately from the charger.
The battery pack was not pushed correctly onto the sliding seat (2).
5

Care and Maintenance

SUPERTRONIC 2000 E:
Remove the battery prior to carrying out any work on the machine.
ON switch: Check that the machine switch unblocks automatically when finger pressure is re-
leased. In case of any anomaly, replace immediately with a new one.
Threading heads: Check that there are no damaged teeth on the head to be used, as thread
quality could be seriously deteriorated. Keep clean of swarf to achieve top quality threading and
longer life.
Gear box.: Change grease every 500 operating hours. After dismounting the machine, oil all
mechanisms to eliminate old grease. Remove parts with dry compressed air and apply new
grease with clean hands. Do not use antdissolvents. Approximately 300 grs. Of grease is need-
ed for a correct lubrication. An excessive amount of grease is not recommended as it can in-
crease the temperature of the machine. Grease type: LGMT2 by SKF or similar. We recommend
that this operation be carried out by an authorized after-sales service.
Dismounting the gear box: Before dismounting the cover of the gear box, never introduce sharp
objects such as tips, screwdrivers, etc. between the body and cover's connecting faces. The cor-
rect procedure is to tap the front of the octagon gently with a plastic hammer.
Tube fastener (clamp): Check that the tube fastener clamp is in good condition. Replace when
tube displacement occurs.
Machine maintenance and repair should be done by a specialist: All repairs should be carried
out by a specialist and only original parts should be used.
Charger:
Repairs to the charger must only be carried out by qualified electricians.
If the mains connection cable of this tool is damaged, in order to prevent endangering personnel
and property it must be replaced by the manufacturer, or the Customer Service of the manufac-
turer, or a similarly qualified person.
6

Troubleshooting

Symptom
Insufficient power
Off-centre threading
Insufficient thread
lenght
20
Possible Reason
Make sure that extension cable is not too long or that it does not
have insufficient section.
Make sure that the right working speed is being used.
Tube clamp must be well secured (bolt parallel to tube).
Check operating condition of threading heads.
Apply plenty and continuous lubrication to threading heads.
Make sure that the tube can be screwed.
Check position of tube fastener (shaft parallel to tube).
Check condition and quality of tube.
Check correct positioning of tube fastener.
Make sure that there is no obstruction between the machine and
the tube fastener.
ENGLISH