DrBrowns AC184 Instrucciones De Uso página 3

4. Replace the Measuring Cup and plug in the power cord.
Note: The first time the unit is plugged in, the warming cycle may begin
automatically. If the Indicator Light is on upon plugging unit in, wait for the
warming cycle to end (Indicator Light will turn off ) and allow the unit to cool
down for 10 minutes before using.
5. Place the bottle or food jar inside the Warming Chamber as outlined below.
• Wide Neck Bottle: Place bottle directly into Warming Chamber.
• Narrow Bottle: Place Adapter Ring on top of Warming Chamber, then place
bottle in Warming Chamber. The Adapter Ring will keep your bottle centered
over the heating plate for even warming.
Note: To prevent leakage when warming Dr. Brown's®
bottles, remove the internal parts, collar, and nipple/teat,
and replace with the included Storage Cap.
• Food Jar: Place food jar into the Lift-Out Basket, then place Lift-Out Basket in
Warming Chamber.
Note: Always remove the lid of the food jar prior to warming. After
warming cycle is complete, be sure to stir food thoroughly until it is an
even temperature throughout.
6. Press the Power Button. The Indicator Light will turn on, indicating the warming cycle
has begun.
CAUTION: Always add water and then press Power Button. If the Power
Button is pressed first, steam may form when water is added.
WARNING: DO NOT reach over the appliance while in use, as steam will cause
burns and serious injuries. Do not touch hot surfaces during or immediately
after use.
Note: If the Power Button is pressed without water added, the unit will shut off
automatically after a short period. If this happens, wait at least 10 minutes to allow
warmer to cool before adding water and starting warming cycle.
7. When the Indicator Light turns off, the warming cycle is done. Remove the
bottle/food jar promptly to avoid overheating. Gently stir or swirl content to ensure
it warms evenly. DO NOT shake.
Note: Always test the temperature before feeding your baby. Adjust the amount of
water added to the warming chamber as needed; if the bottle/food jar is too cold,
add slightly more water next time. If the bottle/food jar is too warm, use slightly less
water next time.
8. Wait at least 10 minutes to allow warmer to cool before using again.
3
1 2
4 5
Wide-Neck
Bottle
6 7
3
Narrow Food
Bottle Jar
8
10
4