Acqua Brevetti PuliFIL FT010 Instrucciones De Instalacion Y Uso página 26

This equipment must not be used to treat water having microbiological parameters not in
compliance with drinking standards.
Prevent solvents, oils, greases, acidic or caustic substances and detergents to come into contact
with the external plastic and brass parts of the equipment.
In case of very strong bumps during transport or assembly, do not install the equipment and
replace it even if there are no patent damages to the plastic parts.
The plumbing system in which the filter is installed and the installation of the filter itself must be
carried out in compliance with best practice, in line with all the current laws in force.
All materials used for the construction of water plumbing systems must be suitable for contact with
water intended for human consumption according to local laws.
B1.3 General instructions for installation
- Once the packaging has been removed, check the filter integrity. If doubt, do not use it and
contact the supplier. Make sure that all listed parts are present.
The construction and modification of a water distribution system intended for human consumption
requires performing the interventions in such a way as not to jeopardize the hygiene of the system.
Before installing the filter, clean all piping and equipment installed before the filter in order to
remove any foreign bodies that could cause filter malfunction.
After the installation the plumbing system intended for human consumption must be washed and/or
disinfected according to the requirements of the EN 806-4 standard.
Warning! Inadequate use, inappropriate hygienic conditions and incorrect installation and
maintenance interventions can lead to contamination of drinking water, damage to the
equipment, leaks and damage caused by water.
B1.4 Hydraulic checks after installation
After having opened the water upstream of the equipment, check for any leaks;
Check that filter is correctly positioned so as to ease ordinary maintenance operations.
Check that system is equipped with: disconnector, by-pass, sampling taps.
Verify there are no leaks from the inlet and outlet fittings and from the filter drain.
Check the compliance of the system with any local regulations or recommendations issued
by the competent local offices
For any doubt, contact Acqua Brevetti SRL (tel. +39.049.8973432, e-mail: servizi@acquabrevetti.it)
B1.5 Allowed assembly diagrams
PULIFIL - ENGLISH
PuliFIL is supplied without assembled covers in order to give
the possibility to:
- Install the filter following the water flow direction
indicated by the arrow stamped on the brass filter
head;
- Use the brass filter head to fix the filter to piping. The
hexagonal in and out brass connections offer a better
grip;
Assembly of the front cover in the front position
-
MAN125 PAG.EN-11
.