Auriol 291528 Instrucciones De Utilización Y De Seguridad página 38

Mounting the temperature station
and / or the outdoor sensor on a wall:
Note: You will require an electric drill and a
crosshead screwdriver for this step.
CAUTION! DANGER TO LIFE, RISK
OF INJURY AND MATERIAL DAMAGE!
Read the operating and safety instructions for
your drill carefully.
Take care that you do not hit electricity, gas or
water lines when you drill into the wall. If nec-
essary, check with a pipe and cable detector
before drilling.
Note: Before mounting the temperature station,
please remove the stand
it off.
Mark the position of the hole (ø approx.
7.7 mm) on the wall.
Drill the hole with an electric drill.
Insert the dowel
hole.
Using a crosshead screwdriver, screw the
screw
Hang the temperature station or outdoor
sensor by placing the hanging slot
to the according screw.
Note: Ensure that the outdoor sensor shouldn't
be immersed into water and not contact with
direct sunlight. Electronic devices may adversely
affect the wireless signal reception.
38 GB/IE
DANGER TO LIFE!
28
, into the dowel.
27 32
by simply pulling
26
, into the drilled
33
,
22 30