Kohler K-T15601 Guia De Instalacion página 4

Copper
Apply plumbers
Tube
putty.
1-1/2" (3.8 cm) -
2-7/8" (7.3 cm)
Setscrew
5/32" Hex
Wrench
1. Install the Spout
CAUTION: Risk of internal seal damage. Do not use
petroleum-based lubricants when installing slip-fit spouts. If the
spout will not slide over the tubing, use soapy water or a
silicone-based lubricant.
CAUTION: Risk of internal seal damage. Loosen the spout
setscrew with a 5/32" hex wrench prior to installing the spout.
Slip-Fit Spouts
Remove the temporary nipple from the bath elbow.
Apply thread sealant and install a 1/2" copper tube so it extends
1-1/2" (3.8 cm) to 2-7/8" (7.3 cm) beyond the finished wall.
Smooth the edge of the copper tubing.
Loosen the setscrew with a 5/32" hex wrench.
Apply a bead of plumbers putty or other sealant around the inlet
end of the spout according to the manufacturer's instructions.
Install the spout and carefully retighten the setscrew. Do not
overtighten the setscrew.
Remove all excess putty.
Threaded Spout
Remove the temporary nipple from the bath elbow.
1006260-2-D
All manuals and user guides at all-guides.com
Nipple
3-7/8"
(9.8 cm)
Nipple
Slip-Fit
Spouts
7"
(17.8 cm)
Threaded Spouts
4
Apply plumbers
putty.
Standard
Length
Spouts
Apply plumbers
putty.
Large Spouts
Kohler Co.