Worx WX670 Manual página 10

SYMBOLS
To reduce the risk of injury, user
must read instruction manual
Warning
Double insulation
Wear eye protection
Wear ear protection
Wear dust mask
10
WEEE marking
High frequency multi-function tool
All manuals and user guides at all-guides.com
OPERATING
INSTRUCTIONS
1. mounting the tool (see a1,a2)
wear protective gloves. Avoid danger of
injury from the sharp edges of the application
tools. Application tools can become very hot
while working, presenting danger of burns!
cut blades or any segment saw blades
face back toward the user's hand.
Unscrew the bolt (7) and remove the flange
(6).
Clean the tool holder, the application tool and
the bolt (7) and flange (6).
Place the application tool exactly onto the
hex-shaped tool holder. Pay attention that the
application tool has a flush fit.
Reposition the flange and tighten the bolt (7)
using the supplied allen key.
2. mounting / changing the
sanding sheet (see b)
Align the sanding sheet and press it onto the
sanding plate by hand.
Firmly press the power tool with the sanding
sheet against a flat surface and briefly switch
the power tool on. This provides for good
adhesion and prevents premature wear.
If one point has become worn, pull off the
sanding sheet, turn it through 120° and place
it on again.
3. operating the on/oFF sWitch
——Switching the power tool ON: Slide switch
(10) forwards (I).
——Switching the power tool OFF: Slide
switch (10) backwards (0).
4. using the Variable speed control
(WX671)
Select oscillation frequency (speed) while the
motor is running.
The variable speed control (1) can be used
note: Before using the tool, read the
instruction book carefully.
caution: For all work or when
changing application tools, always
Warning: to reduce the risk of
injury, do not let the universal end
EN