Worx WX670 Manual página 9

ADDITIONAL SAFETY
POINTS FOR YOUR TOOL
1. Never use your SoniCrafter
applications.
2. Always wear eye protection.
3. Always wear ear protection during
extended periods of operation..
4. Always wear a dust mask if the operation
is dusty.
5. Always inspect and remove all nails and
screws etc before sanding.
6. Always check walls and ceilings to avoid
hidden power cables and pipes. A metal
detector can be obtained from any good
DIY store for this purpose.
7. If possible, use clamping devices or other
suitable means to secure the workpiece to
a firm surface.
8. Use the original accessories and the tool
provided, no others.
9. Only use accessories in good condition.
Do not use torn or worn accessories.
10. Do not use a damaged plug or cord, if
damaged have them repaired. Always be
aware of the cord location.
11. Do not abuse the cord. Never use the cord
to carry the tools or pull the plug from
the outlet. Keep cord away from heat, oil,
sharp edges or moving parts. Replace
damaged cords immediately.
12. Do not restart the cutting operation in the
workpiece, Let the tool reach full speed
and carefully reenter the cut.
13. Unplug your tools before mounting or
replacing accessories.
14. Do not "jam" the cut-off saw blade or
apply excessive pressure, Do not attempt
to make an excessive depth of cut.
15. Keep your hands away from cutting area.
Do not reach under the material being cut.
16. hold power tools by insulated
gripping surfaces when performing
an operation where the cutting tool
may contact hidden wiring or its own
cord. Contact with a "live" wire will make
exposed metal parts of the tool "live" and
shock the operator.
17. The operating instructions and the
enclosed safety information should be
High frequency multi-function tool
All manuals and user guides at all-guides.com
for wet
TM
grinding, drilling and other construction
activities contains chemicals known
to cause cancer, birth defects or other
reproductive harm. Some examples of
these chemicals are:
1) Lead from lead-based paint.
2) Crystalline silica from bricks and cement
3) Arsenic and chromium from chemically-
Your risk from these exposures varies,
depending upon how often you do this type
of work. To reduce your exposure to these
chemicals:
• Work in a well-ventilated area.
• Work with approved safety equipment,
vibrations occur. Adopt the correct working
practices in order to reduce the exposure to
vibration.
careless. Remember that a careless fraction
of a second is sufficient to cause severe
injury.
kept carefully for later use and enclosed
with the machine, should it be passed on
or sold.
Warning! some dust created
by power sanding, sawing,
and other masonry products.
treated lumber.
such as those dust masks that are
specially designed to filter microscopic
particles.
Warning! Whilst working
with this power tool, hand/arm
caution: do not let familiarity
with your sonicrafter
9
make you
tm
EN