Maintenance; Lighting Instructions; Burner Cover Assembly; Control Knob - Agio 2127021 Manual Del Usuario

MAINTENANCE

The flames should look like those in Figure 11. To clean the
burner, use a soft brush after the burner has cooled
completely. Never use a vacuum cleaner on the burner. It is
recommended to store the fire pit indoors during winter if it
will be subjected to freezing temperatures. The LP cylinder
must be disconnected and removed from the appliance
before the appliance can be stored indoors.
Figure 11

LIGHTING INSTRUCTIONS

Warning: If these instructions are not followed exactly, a fire or explosion may result causing
property damage, personal injury, or loss of life.
IGNITER BUTTON Figure 12

CONTROL KNOB

1. Read instructions before lighting.
2. Push and turn the knob to ON.
3. Hold ignitor to light the burner, release control knob after 15 seconds; if burner does not light,
wait 5 minutes, repeat.
4. Adjust flame to desired flame with the control knob. See Figure 12.

BURNER COVER ASSEMBLY

Place the burner cover on the table top as shown in
Figure13.
WARNING: BEFORE PLACING THE BURNER COVER ON,
MAKE SURE THE FIREPIT HAS BEEN SHUT OFF AND THE
BURNER HAS COMPLETELY COOLED DOWN.
Figure 13
11