Installation - Electrolux GC58V Manual De Instrucciones

3. Installation

For your tranquility, Electrolux has a highly
qualified Service Station Network to install your
cooker. Contact Service Station Electrolux, which
are in relation found next to this instructions
manual. For this service, a fee will be charged.
This installation does not cover services like
place preparation (eg. power grid, electrical and
hydraulic connections, masonry, sewer, plugs,
etc.) as they are customer responsibility.
If you prefer, you can even install your cooker,
but you need to follow the instructions in this
manual step by step.
Check before, on the identification label located
in the inferior part of the cooktop:
- The gas type;
For safety, our products leave the factory
configurate to LGP. Contact one of the nearest
Electrolux Authorized Technical Services if you
wish to use your cooktop with NG (natural gas).
If the product has not been used, the conversion
will be free of charge during the warranty
coverage period ( expect the costs of travel of the
Authorized Service when the product is outside
of the Authorized county seat). The conversion
will only be possible
available on site.
Conditions of installation place
The use of a gas coker produces heat and
moisture at the place where it is installed.
Make sure there is air circulation in the installation
room, keeping natural ventilation or installing an
air extractor.
A poor ventilation produces a lack of oxygenation,
which is harmful to the performance of the cooker
and to the health.
Intensive and prolonged use of the cooker
requires an additional ventilation, eg. opening of
a window or an effective ventilation to increase
the air flow.
The air currents should not hinder the proper
functioning of the cooker or tuern the flame out.
if there is natural gas
Parts required
install your
(parts not covered
warranty)
Gas cylinder installation:
1. Exclusive pressure regulator
for your cooker.
2. PVC plastic hose with yellow
stripes or 1/2" flexible metal
hose and adaptor (if the hose
cross behind the cooker).
3. Two metal clamps (good
quality) with bolts.
Procedures for insta-
lling the P13 gas
cylinder with fl exible
metal hose
Use a 22 mm wrench to attach on
of the ends of the flexible metal
hose to the cooktop gas inlet.
Attach the other end of the hose
to the pressure regulator register
(figure 3) using a 26 mm (1 in.)
wrench, without forgetting to use
the sealing ring attached to the
tube.
If the pressure regulator is not
compatible with the flexible metal
hose (figure 4), you must replace
the regulator valve (figure 5).The
usage of connections is not re-
commeded. Check the distance
between the gas cylinder and
the cooktop. If the metal hose of
125 cm of length is not enough,
the instalation should be done
with steel or cooper hoses.Attach
the pressure regulator to the gas
cylinder, apriete tighten it only with
the hands (figure 6). This system
was developed for sealing only
with "manual force", requiring no
tools.Release the gas and check
if there are leaks using viscous
liquid detergent, which ensures
better performance and effecti-
veness in test (figure 7). If blisters
occur, retighten the connections
to eliminate the leaks.
to
cooker
by
Regulador
Hose
Clamp
21