Agri-Fab 45-04733 Manual Del Usuario página 5

11. Attach the lift tube assembly (2) and the hitch tube
(5) to the rear hole on the left side of the tray using a
5/16 x 1-1/2" hex bolt (10) and 5/16" nylock nut (14).
tighten the nut then loosen 1/2 turn.
12. tighten the nuts and bolts shown in figures 2 and 3.
5
13. Attach the lower lift tubes (19) to the lift tube assembly
using two 5/16 x 1-1/2" hex bolts (10) and 5/16" nylock
nuts (14). See figure 6. tighten.
14
10
19
2
14
10
fiGUrE 5
fiGUrE 6
14. Attach the wheels (1) to the lift tube assembly using
a 1/2 x 4-1/8" hex bolt (7), two 1/2" washers (30), a
1/2" jam nut (13) placed between the wheel and the lift
tube assembly and 1/2" a nylock jam nut (12) for each
wheel. See figure 7 .
15. tighten the 1/2" jam nut and 1/2" nylock jam nut so
that the wheel turns freely on the hex bolt.
1
30
30
7
16. Attach the center brace to the bottom of the tray to use
the plug or spike aerator. Attach the center brace to the
front of the tray to use the de-thatcher or roller. tighten
the bolts. See figure 8.
DETHATCHER OR ROLLER
PLUG OR SPIKE AERATOR
5
12
13
fiGUrE 7
fiGUrE 8