CONTROL PANEL FEATURES
1. Fuel Valve Knob.
2. Engine Control Switch: Flip the switch to the "ON (l)"
position and pull the recoil starter to start the
generator. Turn to the "OFF (O)"
off the generator.
3. Push-Button START/STOP:
start the engine. Push again to stop the engine.
Parallel Operation Outlets: These outlets are used for
4.
connecting two AIPOWER inverter generators for parallel
operation. Do not connect or disconnect parallel cables
while the generator is running to avoid damage.
5. Circuit Breaker(AC):Protects the generator
against electrical overloads.
5V DC, USB Outlet: Provides 5 volt DC power up to 1.5
6.
amps.
120V AC, 30A Twist Lock outlet, single phase,60 Hz
7.
Outlet (NEMA L5-30R):
volt output up to 30 amps.
120V AC, 20A Duplex, Single Phase, 60 Hz Outlets
8.
(NEMA 5-20R): Each outlet is capable of carrying a
maximum of 20 Amp on.
NOTE: Total power drawn from all outlets must not exceed the nameplate rating.
1
2
15
14
position to turn
Push once to automatically
This receptacle can provide 120
3
4
13
12
11
10
9
Main Circuit Breaker : Protects the generator
9.
against electrical overloads
10. Wireless Set Button:
key.
11. Ground Terminal:
ground the generator.
12. Battery Charging port:
Low Idle Switch: Consumption and noise by adjusting
13.
the engine speed to the minimum required for the current
load.
14. Fuel Source Switch:
propane/LPG operation.
15. LED Multi-Meter:
remaining,power output,and total running time.
Page 10
4
5
6
8
Used to match the remote start
The ground terminal is used to
Used to charge the battery.
Used to select gasoline or
Displays voltage, frequency, fuel
7