Do Not Overload Generator; Changing Fuels - Power SUA3800iED Manual

Do Not Overload Generator

Overloading a generator in excess of its rated wattage
capacity can result in damage to the generator and to
connected electrical devices.
To prolong the life of your generator and attached
devices, follow these steps to add electrical load:
1. Start the generator with no electrical load attached.
2. Allow the engine to run for several minutes to
stabilize.
3. Plug in and turn on the first item. It is best to
attach the item with the largest load first.
4. Allow the engine to stabilize.
5. Plug in and turn on the next item.
6. Allow the engine to stabilize.
7. Repeat steps 5-6 for each additional item.

Changing Fuels

DANGER
Gasoline, gasoline vapor and propane/LPG are highly
flammable and explosive.
Fire or explosion can cause severe burns or death.
DANGER
DO NOT add gasoline to the gasoline tank or connect
the Propane/LPG hose to the generator while the
generator is running.
1.Disconnect all electrical loads from the generator.
2. Stop the engine (generator). See the "Stopping the
Engine (Generator)" section for stopping procedure.
3a. Gasoline to Propane/LPG
• Turn the fuel switch to the "OFF"
• Fully open the Propane/LPG cylinder knob.
• Turn the fuel source switch to the LPG
3b.Propane/LPG to Gasoline
• Make certain the propane tank is fully closed.
Page 23
position.
position.