Remote Control Programming - Power SUA3800iED Manual

Remote Control Programming

Before the generator can be started , an initial start-up
procedure must be performed so the generator and the
remote control recognize each other.
NOTE:
YOUR REMOTE CONTROL IS ALREADY PROGRAMMED
INFACTORY FOR YOUR CONVENIENCE.AND IT IS
READY TO START THE GENERATOR.
If the remote control is replaced then you will need to
go through following procedure with new remote
control.
1. Turn the engine switch to the "ON"(l) position.
2. Press and hold the wireless set button for 3-5
seconds until the indicator light of the engine
START/STOP switch turns on.
Indicator Light
Press and hold the STOP button of the remote control
3.
switch until the indicator engine START/STOP switch
flashes and then stays on.
STOP
Wireless Set Button
Press and hold the START button of the remote
4.
control switch until the engine START/STOP switch
flashes and then stays on.
Turn off the engine switch to "OFF"(O)
5.
to complete the pairing.
Page 12
START
position