Stand By; Usb Port - Zummo Viva Manual De Servicio

6.3. STAND BY

The juicer has a stand-by mode which operates automatically at
the end of the last squeezing cycle. When the juicer is in stand-by
mode, the mode button it is in remains on and the oval display is
off.
To wake up the juicer from this mode, press any of the two buttons.

6.4. USB PORT

Available from version 2.
6.5. LIMPIEZA
The squeezing zone should be cleaned every day.
· When the juicer is stopped, switch off the power switch (Fig. 4).
Then disconnect it from the power supply.
· Remove the front cover and upper lid (Fig. 5), clean them with
a cloth moistened in a neutral soapy solution. WARNING!
NEVER clean these parts with abrasive products.
· Pull the juicing block out horizontally (Fig. 6). To disassemble
the juicing block, firstly remove the blade and cups by holding
the blade handles and pulling upwards (Fig. 7). Then remove
the cups. To do so, we advise lifting the cup slightly over the
stops and then pulling slightly outwards (Fig. 8). TAKE GREAT
CARE WITH THE CUTTING BLADE as it is very sharp and you
could cut yourself. We advise fitting the blade protector once
it is clean in order to carry on cleaning the juicer safely (Fig. 9).
Remove the balls by holding the handles and pulling upwards,
using both hands to ensure correct removal (Fig. 10). Finally,
remove the filter tray by pulling outwards horizontally (fig. 11).
To remove the filter shaft, pull upwards (Fig. 12). You can either
put these parts in a dishwasher at a maximum temperature of
70°C or wash them by hand.
· Wash the bin and drip grill.
· Clean the front of the juicer, the upper lid and the feeder pad-
dle with the same soapy water solution.
Note:
In the event of inappropriate cleaning, the guarantee will be ren-
dered void.
ASSEMBLY
When all these parts have been cleaned, reassemble the juicer in
the following order:
1 Fit the filter shaft to the filter tray, you will notice a slight click
when it fits into place (Fig. 13). Next fit the squeezing tray
assembly by introducing it in the slots on the squeezing tray
(Fig. 14). You should notice a slight click when it fits into place.
This means that it has been fitted properly.
2 Introduce the balls in the squeezing tray. Check that they are
fitted properly (Fig. 15).
3 Fit the cups to the blade making sure they are properly po-
sitioned (Fig. 16). Then fit the assembly in the squeezing tray
and fit the slides in the ball slots (Fig. 17). Take care not to
cut yourself!
4 Fit the juicing block to the juicer, making sure it reaches the
back (Fig. 18).
5 Fit the front cover and upper lid (Fig. 19). You will hear a click
indicating that they have been fitted properly.
6 Fit the bin and drip grill.
Service Manual
23