Thermador PCG305W Manual De Instrucciones página 6

9 IMPORTANT SAFETY INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS
Do not use the grill plate accessory for cooking
excessively fatty meats or products which promote flare-
ups.
When cooking fatty or oily foods on burners, the grill, or
the griddle, adjacent gas burners can ignite airborne
fumes. Use caution to avoid burns.
IMPORTANT: There is a possibility to discolor the back
wall under certain cooking conditions.
DO NOT store or use corrosive chemicals, vapors,
flammables, or nonfood products in or near this appliance.
It is specifically designed for use when heating or cooking
food. The use of corrosive chemicals while heating or
cleaning will damage the appliance and could result in
injury.
DO NOT TOUCH SURFACE UNITS OR AREAS NEAR
UNITS – Surface units may be hot even though they are
dark in color. Areas near surface units may become hot
enough to cause burns. During and after use, do not
touch, or let clothing or other flammable materials contact
surface units or areas near units until they have had
sufficient time to cool. Among these areas are the
cooktop and surfaces facing the cooktop.
SMART-ENABLED APPLIANCES—REMOTE OPERATION
This appliance may be configurable to allow remote
operation at any time. Do not store any flammable
materials or temperature sensitive items inside, on top or
near surface units of the appliance.
REQUIREMENTS AND STANDARDS
• The appliance must be electrically grounded in
accordance with local codes or, in the absence of local
codes, with the with the National Electrical Code,
NFPA 70 or the Canadian Electrical Code, CSA C22.1.
• Installation must conform with local codes or, in the
absence of local codes, with the National Fuel Gas
Code, ANSI Z223.1/NFPA 54 or, in Canada, the
Natural Gas and Propane Installation Code, CSA
B149.1.
• Installation of appliances designed for manufactured
(mobile) home installation must conform with the
Manufactured Home Construction and Safety
Standard, Title 24 CFR, Part 3280 [formerly the
Federal Standard for Mobile Home Construction and
Safety, Title 24, HUD (Part 280)] or with local codes
where applicable.
• Installation of appliances designed for recreational
park trailers must conform with state or other codes
or, in the absence of such codes, with the ANSI
A119.5 Park Model Recreational Vehicle Standard.
6
• See the Installation Instructions for electrical
requirements, grounding instructions and clearance to
combustible material requirements.
• Service should only be done by an authorized service
provider.
• It is the responsibility of the owner and the installer to
determine if additional requirements and/or standards
apply to specific installations.
GAS REQUIREMENTS
• A manual valve must be installed in an accessible
location in the gas piping external to the appliance for
the purpose of turning on or shutting off gas to the
appliance.
• In the event a burner goes out and gas escapes, open
a window or a door. DO NOT attempt to use the
appliance until the gas has had time to dissipate. Wait
at least 5 minutes before using the appliance.
• For Massachusetts installations:
• Installation must be performed by a qualified or
licensed contractor, plumber or gas fitter qualified
or licensed by the state, province or region where
this appliance is being installed.
• Shut-off valve must be a "T" handle gas cock.
• Flexible gas connector must not be longer than
36'' (914 mm).
• The maximum depth of cabinets installed above
cooking surface must be 13'' (330 mm).
• Natural gas – 7 in. w.c. (17.4 mbar) minimum, 14 in.
(34.9 mbar) maximum
• Propane gas – 11 in. w.c. (27.4 mbar) minimum, 14 in.
(34.9 mbar) maximum
PROPOSITION 65 WARNING
This product may contain a chemical known to the State of
California, which can cause cancer or reproductive harm.
Therefore, the packaging of your product may bear the
following label as required by California:
State of California Proposition 65 Warning:
:
WARNING
Cancer and Reproductive Harm -
www.P65Warnings.ca.gov
Disposal of packaging
The packaging materials are environmentally compatible
and can be recycled. Sort the individual components by
type and dispose of them separately. Information about
current disposal methods can be obtained from your
specialist dealer or local authority.