Before Using For The First Time; Before You Begin; Placing The Burner Caps; Checking The Burner Cap Placement - Thermador PCG305W Manual De Instrucciones

Before using for the first time

The graphics are representative. Your appliance may have
different appearances.
9 WARNING
All knobs must be set to OFF before powering up the
rangetop. To prevent unintended operation at power up,
please set all knobs to OFF.

Placing the burner caps

9 WARNING
To prevent flare-ups and avoid the creation of harmful by-
products, do not use the rangetop without all burner caps
and all burner grates properly positioned.
9 WARNING
To prevent burns, do not touch burner caps or grates
while hot. Turn the rangetop off and allow the burners to
cool.
The burner caps must be properly placed on the burner
bases for the cooktop to function properly. If the burner
cap is not properly placed, one or more of the following
problems may occur:
• Burner flames are too high.
• Flames shoot out of burners.
• Burners do not ignite.
• Burner flames light unevenly.
• Burner emits gas odor.
Each cap has a letter (B, D, or F) cast in the underside of
the cap that corresponds to a letter (B, D, or F) cast in the
burner base that is attached to the appliance.
1. Place each burner cap on its correct burner base per
its corresponding letter designation.
2. Place burner cap gently on top of base so that the
prongs of the burner base fit snugly into the groove of
the burner cap.
8

Checking the burner cap placement

• Check each burner to make sure there is no gap
between the burner cap and burner base.
• You may gently try to move the burner caps from side
to side to check if the caps are properly placed on the
burner bases.
• When properly placed, each burner cap will rest flat
on top of its burner base, and completely cover the
star-shape of the burner base when viewed from the
top as shown below.
Automatic re-ignition
Each burner has its own electronic igniter that sparks
when the burner is turned on. Each burner should light in
four seconds or less. If a burner does not light, check to
see that the cap is positioned correctly on the base.
If any one or more burners blow out, the electronic igniter
automatically activates to re-light the flame. Do not touch
the burners when the igniters are active.
For flame height verification and adjustment instructions,
refer to the Installation Instructions included with the
appliance.