Lionelo Bastiaan One Manual De Usuario página 18

ISOFIX (optional)
a.
If necessary, put ISOFIX covers on ISOFIX connectors in the car.
They help you stick ISOFIX fasteners when car connectors are
hard to access.
b.
Position the child safety seat on the car seat in a forward-facing position.
c.
Press ISOFIX button to pull out both ISOFIX arms. Grab the child
safety seat and slide two ISOFIX arms into fasteners located in the
car seat until they engage and you can hear a distinctive „click".
d.
Push the child safety seat against the car seat as far as you can.
The marker on both sides of ISOFIX arms should turn from red into
green (fig. 24a).
TOP TETHER (optional)
a.
Pull out TOP TETHER fixing belt and unroll it with the use of
adjustment device (fig. 24a).
b.
Fasten TOP TETHER in the spot recommended in the vehicle manual.
The upper belt fastening spot may differ, depending on the car model
(the example of location of fastening spots has been showed in the
example of group 0+ in fig. 21).
c.
Fasten TOP TETHER fixing belt so that a green indicator shows up
on the buckle
CAR SEAT BELTS (required)
a.
Position the child safety seat on the car seat in a forward-facing position.
b.
Put the child in the child safety seat.
c.
Pull the car seat belt and carry its shoulder part through belt guide
in the headrest (element marked as 1 in fig. 3).
d.
Carry the hip part of the car seat belt through the guide (marked
as 15 in fig. 3) (fig. 24b).
e.
Fasten the belts. Press the child safety seat against the car seat.
Tighten the belts as showed by arrows in figure 24b. Make sure
they are not too tight and do not limit the child.
f.
Move the child safety seat to check it is has been securely fixed. If
fixing of the product is unstable, adjust the belt tension.
EN ‑ 18 ‑