Lionelo Braam Manual De Usuario página 14

• Do not assemble the child safety seat on a front seat if its airbag is active.
2. Installation in a forward-facing position, the child is secured with safety belts of the
child safety seat (group I, 9 - 18 kg).
• Set the child safety seat in a forward-facing position.
• Rotate the child safety seat to the forward-facing position. To do so, press the base
360° rotation button (M) (see: fig. 13).
• Press the support leg adjustment button (Y), next extend the leg and adjust its length
so that it contacts the vehicle floor (the indicator will turn green when the support leg
is properly extended).
• Pull the car seat belt.
• Carry the shoulder part of the belts (D) through the shoulder belt guide (A) marked in red.
• Carry the hip part of the belt through the hip belt guide (P) marked in red.
• Press the child safety seat against the car seat as much as you can. Pull the hip belt
towards the buckle to tighten it as much as possible. Next pull the shoulder belt to
tighten other parts of the belt; make sure the belts are not twisted and properly secure
the child safety seat.
• Put the child in and secure with safety belts of the child safety seat. (See: fig. 2)
3. Installation in a forward-facing position, the child secured with car seat belts (group
II, III, 15 - 36 kg).
• Remove 5-point safety belts. (see: fig. 8 and 9)
• Place the child safety seat on the car seat.
• Turn the child safety seat to a forward-facing position. To do so, press the base 360°
rotation button (M) (see: fig. 13).
• Press the support leg adjustment button (Y), next slide the leg in and adjust its length
so that it is as short as possible and the indicator turns red.
• Put the child in the child safety seat.
• Pull the car seat belt.
• Carry the shoulder belts (D) through the guide in the headrest (A) marked in red. (See:
fig. 23)
• Carry the hip part of the belt through the hip belt guide (P) marked in red.
• Press the child safety seat against the car seat as much as you can.
• Carry both belts through the hip belt guide (P) marked in red and fasten the belts.
(See: fig. 25)
Information:
• Check if the safety belt goes through the shoulder and if it is at a relevant distance
between the neck and shoulder – mark A and B (see: fig. 22).
EN ‑ 14 ‑