Flat Type Printhead - Load Label Roll In Peel Off Mode - Valentin SPE II Guía De Referencia Rápida

SPE II
Flat Type Printhead – Load Label Roll in Peel off Mode
I
H
G
F
E
D
•
Open the cover of printing system.
•
Open the printhead (H) by turning the pressure lever (I) anticlockwise.
•
Lead the label material below the label guiding (B) and printhead (H) and take care that the labels run through the photocell
(A).
•
Move the printhead (H) down by turning the pressure lever (I) in clockwise direction until it locks.
•
Adjust the adjusting rings (C) of the label guiding to the width of material.
•
Turn the locking lever (F) upwards in clockwise direction while turning the dispenser whip (D) downwards.
•
Strip some labels from the backing paper and lead the backing material over the dispensing whip (G) and between the
plastic roll (E) and the dispensing whip-shaft (D).
•
Press again the dispensing whip (D) to the top and lock it.
•
Lead the supporting paper to the back and fix it at a rewinding unit.
•
Enter the offset value in the Dispenser I/O menu.
•
Close the cover of printing system.
76
A
B
C
English