Technoline WS 8118-IT Manual De Instrucciones página 24

Note: The day can only be set in conjunction with the selected month. For example, it is not
possible to set the data 30 if the months of February is selected.
Press and release the SET key to enter the "Weekday Setting".
2.
WEEKDAY SETTING
1. The weekday symbols will be displayed on LCD2 in the pre-set language and flashing. Set
the desired weekday by use of the + key.
Press and release the SET key to enter the mode "12/24 Hours Time Display Setting".
2.
12/24 HOURS TIME DISPLAY SETTING
The "12h" or "24h" will start flashing in LCD1 (Default setting 24h). Select the desired
1.
time display mode by use of the + key.
Press and release the SET key to enter the "ºC/ºF Temperature Setting".
2.
°C OR °F TEMPERATURE SETTING
The characters "°C" or "°F" will start flashing on LCD1 (Default setting °C). By use of the
1.
+ key select "°C" for temperature display in degrees Celsius or "°F" for degrees
Fahrenheit.
2. Press and release the SET key to exit the setting mode and switch back to the normal
display mode.
EXIT THE MANUAL SETTING MODES

To return to the normal display mode from anywhere in manual setting mode simply press
the SNZ key anytime.

If no keys are pressed for about 15 seconds in setting mode, the Moonphase wall clock will
automatically switch back to normal display mode.
ALARM SETTING
To enter into the alarm setting mode:
1. Hold the ALM key for 2 seconds. The hour digits start flashing.
2. Press the + key to set the hour.
3. Press and release the ALM key to set the minutes. The minute digits start flashing.
4. Press and release the + key to set the minutes. If the + key is held, the unit will increase
by 5.
5. Press and release again the ALM key to exit the Alarm setting mode or wait for 15
seconds automatic timeout or press the SNZ key.
Note: the alarm duration is about 85 seconds
EN7