How To Use The Dehydrator; Food Safety Tips - Weston DH07 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

HOW TO USE THE DEHYDRATOR

NOTES:
Food should be stored in an airtight container once properly cooled.
To start, pause, or reset: Press or press and hold the
To change time or temperature during drying without pausing or resetting:
Press the
Time Button once or the
will flash. Use arrows to adjust. Unit will continue drying automatically at the new
setting.
1. Place Dehydrator on a flat, sturdy surface with 6 inches of space around the
appliance for proper air ventilation.
2. Make sure the Drip Tray is on the bottom of the Dehydrator to catch food pieces or
drippings.
3. Plug in unit. Dehydrator will beep for 1 second.
4. Load Trays with food into slots. Make sure all 10 Trays are in the Dehydrator, even
if all Trays don't have food.
5. Close Door.
6. Press
ON/OFF (I/ ) Button to turn on. Default temperature 130°F (54°C) will flash
in Display for 5 seconds.
7. Press
or
Button to increase or decrease the temperature.
8. Press
Time Button to select desired time. Default time 10 hr will flash in Display
for 5 seconds.
9. Press
or
Button to increase or decrease the time.
10. Press
Pause/Start Button to begin dehydrating.

FOOD SAFETY TIPS

For food safety, to help ensure any bacteria present are destroyed, choose
pretreatment or post treatment from below:
Pretreatment of Meat Prior to Dehydrating – Preheat a standard oven to 350°F
(177°C). Drain and discard marinade, if used, from meat. Pat dry with paper towels
and place meat in a single layer, leaving a space around each piece on baking
sheet. Bake 5 to 10 minutes or until internal temperature reaches 160°F (72°C).
Poultry must reach 165°F (74°C). NOTE: This method may reduce drying time and
may result in a drier texture.
Post Treatment of Meat After Dehydrating – Preheat a standard oven to 275°F
(135°C). Line a large baking sheet with foil. Place jerky in a single layer, leaving a
small space around each piece. Bake for 10 to 12 minutes. Cool completely on a
wire rack. Pat jerky dry with paper towels to remove any surface fats before storing.
6
Pause/Start Button.
Temperature Button twice. The last setting

Publicidad

Tabla de contenido
loading

Tabla de contenido