WARNING: Always switch OFF the Air Cooler and unplug it from the electrical source before
cleaning or maintenance. Cleaning At least once a week, drain the water tank completely and
refill with fresh water. Doing this will greatly reduce mineral deposits and help to extend the
life of the water pad. End of Season Storage If the Air Cooler will not be used for a long time:
Make sure all parts are dry by running the Fan Only mode for about 30 minutes before storing
(time depends on ambient humidity conditions). Switch OFF the Air Cooler and unplug from
the power supply. Empty/drain all the water from the tank. Clean the water tank with a damp
cloth to wipe away any dust or mineral deposits. Remove the water pad from the Air Cooler
and rinse under fresh water to remove dust and dirty ( Do not rub the mesh with your hand to
avoid deformation and deformation of the net, affecting the wind), and put it back into the
fuselage. See Figure A below . To protect the unit from dust and scratches, cover with a
clean cloth or plastic bag before storing. Coil the power cord and store it away from the floor
to protect it.
CLEANING & DRAINING THE WATER TANK
If the cooler will not be used for a long period of time, please refer to the STORAGE &
MAINTENANCEGUIDELINES located in the separate Safety & Maintenance Guide.
WARNING:
Before cleaning the unit, switch the unit OFF and disconnect from the electrical socket.
unscrew the water pump knob, pull out the water tank, clean the water tank and put it back,
and screw the water pump knob to the water pump. See Figure B below
Refill the water tank with clean water and drain it completely. Refill the water tank with clean
water, up to the maximum level. Use a damp cloth to remove the dirt and dust from the
surface of the unit. Never use corrosive elements or chemicals to clean this product. When
the product is not in use, store the unit in a dry place out of direct sunlight.
4