Riello Hi, Comfort 100 Manual Instalador Y Usuario página 118

EXAMPLE OF LINKED HI, COMFORT T100
1
2
SET
PROG
RESET
1 Radio frequency channel
2 Receiver (WiFi Box) number
3 Radio frequency address
4 number of the thermostat as-
signed by the WiFi Box (in the event
of several linked thermostats) –
identifying the zone.
EXAMPLE OF LINKED HI, COMFORT T100
SET
PROG
RESET
5 number of
(Hi, Comfort T100)
To complete the link, press the SET/PRO-
GRAM button or wait for Hi, Comfort T100
ESC
MODE
4
ESC
MODE
3
5
ESC
MODE
the transmitter
to return to the HOME screen.
9
This may take up to 2 minutes,
after which the Hi, Comfort T100
automatically returns to the HOME
screen.
Should the link not be successful, please
contact the Authorised Service Centre.
NOTE
When replacing the WiFi Box it is neces-
sary to repeat the linking again between
the WiFi Box and Hi, Comfort T100.
Linking the boiler RF receiver to the
WiFi Box
If installing a boiler RF receiver, please
follow the procedure below.
Press the prismatic dome clear LED but-
ton (A) on the WiFi Box and hold for 5
seconds until the green and red LEDs
slow flash at the same time (1 sec).
Press and hold again for 5 seconds un-
til the green and red LEDs momentarily
switch off and then flash slowly (every
2 seconds).
WiFi Box
Press the prismatic dome clear LED but-
ton (B) on the boiler RF receiver and
hold for 5 seconds.
The green and red LEDs of the WiFi Box
flash quickly (0.5 sec) and at the same
time to indicate the successful connec-
tion.
Press the button on the WiFi Box again
118
Boiler RF
receiver
A B