Setting The Heating/Cooling Time Program In Automatic Operating Mode - Riello Hi, Comfort 100 Manual Instalador Y Usuario

If the password has already been set,
"00" is displayed; enter the password
using the UP and DOWN
and press SET to confirm.
If the password entry is correct and the
button function is enabled, the text
"LOC" is displayed for 5 seconds in place
of the ambient temperature, and the
functions of all individual buttons are
disabled.
SET
PROG
RESET
If the password entry is incorrect, the
display returns to the main menu.
When the keypad is blocked and any
button is pressed, the text "LOC" is dis-
played for 5 seconds.
To re-enable button functions, press
the buttons FORWARD
multaneously for 5 seconds, after which
the password is requested.
If the password entry is correct, the text
"UnL" is displayed for 5 seconds in place
of the ambient temperature, and the
functions of all buttons are re-enabled.
buttons
ESC
MODE
ESC
MODE
and UP si-
96
If the password entry is incorrect, the
text "LOC" is displayed for 5 seconds in
place of the ambient temperature, and
the functions of all individual buttons
remain disabled.
Reset password - key lock
To reset the password press the FOR-
WARD and UP
time and hold for 5 seconds; you are
then asked to enter the password and
"00" is displayed.
Press the BACK and DOWN
at the same time and hold for 5 seconds
to reset the old password and "--" is
displayed.
Press SET/PROG to return to the home
screen without entering the password
(with the buttons unlocked) or set a
new password using the UP
DOWN buttons and confirm using
SET/PROG, returning to the main screen
either with the buttons disabled, "LOC"
(where the last status was "UnL") or
with the buttons enabled, "UnL" (where
the last status was "LOC").
When the power is turned ON, the but-
tons show the same status as when the
power was switched off.
If the password is not entered after 2
minutes, the device returns to the main
screen.
3.7 Setting the heating/
cooling time program
in automatic operating
mode
From the HOME screen, press the SET/
PROGRAM button to open the user
menu.
SET
PROG
RESET
buttons at the same
buttons
and