Preparation For Operation - hillvert HT-LOGAN-14SA Manual De Instrucciones

3.2.
LOCATION OF THE DEVICE
The ambient temperature must not exceed 45°C and ambient humidity should not
exceed 85%. Use the device in properly ventilated spaces. Do not block the outlet of
the device tank. Keep the device away from any hot surfaces.
ASSEMBLY OF THE DEVICE
Always drain and clean the tank before installing the device for each mode of
operation.
Liquid substances sprays
1. Remove the tank by unscrewing the two fixing screws (a).
2. Replace the liquid spray cap (G). Place a coupling (2) in the outlet (F) for
connecting hoses. Inside, put the gasket (1) on the outlet (F), on the outside
secure the coupling (2) against falling out by screwing the nut (3). Connect
the rubber hoses inside the tank. Connect one end of the supply hose (D) to
the center of the filter mesh (C) and the other end to the spray cap. Connect
7. Tube
8. Valve dosing amount of liquid supplied to the nozzle
9. Handle
10. Harness
11. Spark plug wire
12. Starter cord holder
13. Suction lever
14. Fuel line
15. Fuel valve
16. Air filter cover
17. Fuel tank
18. Fuel filler cap

Preparation for operation