Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
3.4.
a)
Before cleaning, adjustment, replacement of accessories, and when the device
is not in use, turn off the engine and disconnect the spark plug wire and wait
until the device has cooled completely.
Wait until the rotating parts stop.
•
b)
Use only non-corrosive cleaning agents for cleaning the surfaces.
c)
After each cleaning, all the parts should be dried well before the device is used
again.
d)
Store the device in a dry and cool place protected from moisture and direct
sunlight.
e)
Do not spray the device with a stream of water or immerse it in water.
f)
Make sure that no water enters through the ventilation openings in the
housing.
g)
Clean the ventilation openings with a brush and compressed air.
h)
Perform regular inspections of the device checking technical fitness and any
damages.
i)
Use a soft, damp cloth for cleaning.
j)
Do not use sharp and/or metal objects (e.g. a wire brush or metal spatula) for
cleaning, as these may damage the surface of the material from which the
device is made.
k)
Do not clean the device with acidic substances, medical products, diluent,
fuel, oil or other chemicals as this may cause damage to the device.
l)
After each use, thoroughly clean the tank and other parts of the device from
chemical residue. After cleaning, run the machine for 2-3 minutes to remove
any residual water, etc.
•
CAUTION: Disassembly, replacement and gap adjustment must be done when the
engine is cold (cold plug)!
- To replace a spark plug, first, clean the area of debris to prevent it from getting it
into the socket, then remove the spark plug boot and clean the socket.
- Use the wrench provided to unscrew the spark plug.
- Check the spark plug for wear or damage. If necessary, replace with a new one
(Note: always replace with the same type of spark plug). If the spark plug is to be
reused, clean it with a wire brush.
- Check the spark plug gap, adjust if necessary. The gap between the electrodes
should be: 0.6-0.7mm.
Cleaning and maintenance
Spark plug
Publicidad
Tabla de contenido
