Makita DTW284 Manual De Instrucciones página 8

Reversing switch action
► Fig.7: 1. Reversing switch lever
CAUTION:
Always check the direction of
rotation before operation.
CAUTION:
Use the reversing switch only after
the tool comes to a complete stop. Changing the
direction of rotation before the tool stops may dam-
age the tool.
CAUTION:
When not operating the tool,
always set the reversing switch lever to the neu-
tral position.
Changing the impact force/mode
► Fig.8: 1. Changed in four steps 2. Hard impact
mode 3. Medium impact mode 4. Soft impact
mode 5. Reverse rotation auto stop mode
6. Button
You can change the impact mode in four steps: hard,
medium, soft, and reverse rotation auto stop mode.
To select the step, press the button
Specifications of each impact force grade
Impact force grade displayed
on panel
Hard
Medium
Soft
Reverse rotation auto stop
mode
NOTE: Reverse rotation auto stop mode is available only when the tool rotates counterclockwise. When rotating
clockwise in reverse rotation auto stop mode, the impact force and speed are the same as Hard impact mode.
.
Maximum blows
-1
3,500 min (/min) Tightening when force and
speed are desired.
-1
2,600 min (/min) Tightening when you need
good controlled power.
-1
1,800 min (/min) Tightening when you need fine
adjustment with small diameter
bolt.
-1
3,500 min (/min) Loosening with auto stop
function.
8 ENGLISH
This tool has a reversing switch to change the direction
of rotation. Depress the reversing switch lever from the
A side for clockwise rotation or from the B side for coun-
terclockwise rotation.
When the reversing switch lever is in the neutral posi-
tion, the switch trigger cannot be pulled.
You can change the impact force within approximately
one minute after releasing the switch trigger.
Hard, Medium, and Soft impact mode allows a tighten-
ing suitable to the work.
The function of reverse rotation auto stop mode works
only with pulling the trigger fully in counterclockwise tool
rotation. When the bolt/nut gets enough loosened, the
tool stops the impact and rotation.
Application Work
Assembling the steel frame.
Assembling or disassembling
scaffolds or framework.
Assembling furnitures.
Disassembling bolts/nuts.