Preparation For Operation - MSW Motor Technics MSW-DA-16 Manual De Instrucciones

5. Inertia hammers with hooks (lengths: 650 mm; 630 mm, 730 mm)
6. Inertia hammer with claws for extracting dents (dimensions:
100 mm x 650 mm)
7. Inertia hammers with suction cups (lengths: 620 mm.
8. Suction cup
9. Hooks
10. Slip hammer for welding gun (spotter) (length: 420 mm.
11. Pneumatic inertia hammer (length: 620 mm.

3.2. Preparation for operation

CONNECTING TO THE WELDER:
1. Loosen the housing screws.
2. Remove the top of the housing and route the welder cable through the gun:
route one end of the cable to the trigger and the other end through the head to
the handle.
3. Secure the handle by tightening the screws.
4. Screw the housing.
WHEN CONNECTED TO THE WELDER:
• do not touch the welding fixtures,
• use face, eye and hearing protection,
• do not touch electrically live objects with the gun,
• check if the power cable is damaged,
• do not interfere with the gun structure, before performing any operations
disconnect the gun from the welder.