Intended Use - Makita TW004G Manual De Instrucciones

ENGLISH (Original instructions)
SPECIFICATIONS
Model:
Fastening capacities
Square drive
No load speed (RPM)
Impacts per minute
Overall length
Rated voltage
Net weight
• Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
• Specifications may differ from country to country.
• The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heavi-
est combination, according to EPTA-Procedure 01/2014, are shown in the table.
Applicable battery cartridge and charger
Battery cartridge
Charger
• Some of the battery cartridges and chargers listed above may not be available depending on your region of residence.
WARNING:
Only use the battery cartridges and chargers listed above. Use of any other battery cartridges
and chargers may cause injury and/or fire.

Intended use

The tool is intended for fastening bolts and nuts.
Noise
The typical A-weighted noise level determined accord-
ing to EN62841-2-2:
Model TW004G
Sound pressure level (L
Sound power level (L ) : 110 dB (A)
WA
Uncertainty (K) : 3 dB (A)
Model TW005G
Sound pressure level (L
Sound power level (L ) : 110 dB (A)
WA
Uncertainty (K) : 3 dB(A)
NOTE: The declared noise emission value(s) has been
measured in accordance with a standard test method
and may be used for comparing one tool with another.
NOTE: The declared noise emission value(s) may
also be used in a preliminary assessment of exposure.
Standard bolt
High tensile bolt
Max impact mode
Hard impact mode
Medium impact mode
Soft impact mode
Max impact mode
Hard impact mode
Medium impact mode
Soft impact mode
) : 99 dB (A)
pA
) : 99 dB(A)
pA
TW004G
D.C. 36 V - 40 V max
BL4020* / BL4025* / BL4040* / BL4050F / BL4080F
* : Recommended battery
DC40RA / DC40RB / DC40RC
WARNING:
Wear ear protection.
WARNING:
The noise emission during actual
use of the power tool can differ from the declared val-
ue(s) depending on the ways in which the tool is used
especially what kind of workpiece is processed.
WARNING:
Be sure to identify safety measures
to protect the operator that are based on an estima-
tion of exposure in the actual conditions of use (tak-
ing account of all parts of the operating cycle such
as the times when the tool is switched off and when
it is running idle in addition to the trigger time).
Vibration
The vibration total value (tri-axial vector sum) deter-
mined according to EN62841-2-2:
Model TW004G
Work mode: impact tightening of fasteners of the maxi-
mum capacity of the tool
Vibration emission (a
Uncertainty (K) : 1.5 m/s
4 ENGLISH
TW005G
M10 - M20
M10 - M16
12.7 mm
-1
0 - 3,200 min
-1
0 - 2,600 min
-1
0 - 1,800 min
-1
0 - 1,000 min
-1
0 - 4,000 min
-1
0 - 3,400 min
-1
0 - 2,600 min
-1
0 - 1,800 min
144 mm
1.8 - 3.1 kg
2
) : 16.5 m/s
h
2