Handle Removal And Replacement; Transportation - Greenlee 555 DELUXE Manual De Instrucciones

Handle Removal and Replacement

The handle of the 555 is designed to be removable.
This feature is convenient when performing complex
bending, and makes it easy to replace a damaged
handle.
Removal
1. Place the bender in the upright position.
2. Release the spring clip on the safety snap pin (78).
3. Remove the pin from the handle (79) and the
sleeve of the frame (1).
4. Repeat Steps 1 through 3 for the other end of the
handle.
5. Lift the handle to remove.
Replacement
1. Insert the handle (79) into the sleeves of the frame
(1).
2. Align the holes in the handle with the holes in the
sleeves.
3. Insert the safety snap pin (78). Ensure that the pin
goes through the handle and the sleeve on the
frame (1).
4. Engage the safety spring clip over the end of the
pin. Ensure that the loop on the clip is completely
around the pin.
5. Repeat Steps 2 through 4 for the other end of the
handle.
Removing or Replacing Handle
79
1
78
Greenlee Textron / Subsidiary of Textron Inc.
All manuals and user guides at all-guides.com
®
555 Deluxe Electric Bender

Transportation

Make sure that the handle is properly installed and
secured with the safety spring clips and snap pins
before lifting or moving the bender. An improperly
installed handle could allow the bender to fall,
injuring nearby personnel.
Failure to observe this warning can result in severe
injury or death.
The only proper way to lift this bender is by attaching a
nylon or polyester sling around the storage spindle. The
sling should extend between the handle and main frame
of the bender so that the handle acts as a guide for the
sling, as shown.
Make sure that all components used to lift this bender
are properly rated for the 167 kg (368 lb) weight. Use a
ramp to load and unload from a truck or other vehicle
that is not equipped with a lift gate.
Transporting Bender
25 4455 Boeing Dr., Rockford, IL 61109-2988 815/397-7070