Useful Tips; Controls And Inicators; Temperature Controller - Sagola PACK 6000X Manual De Instrucciones

07. Useful tips

Use the lowest spray pressure in the spray gun or application tool. That which allows you to obtain
the desired finish. Not all products require the maximum pressure to be properly sprayed. With a
lower pressure one will obtain an additional increase in product transfer.
If you install a pressure regulator always mount it before the PACK 6000X to avoid possible
overheating and dilation of the regulator. Set it to the minimum pressure required to optimise the
performance of the PACK 6000X and save energy.
Please note that not all types of paint can be applied with hot air and that this may even cause
imperfections in the paint finish.

08. Controls and inicators

8.1.- Temperature controller

9
10
11
12
3
1 Process value (PV)
2 Set point (SV)
3 Screen No.
4 OUT 1 indicator
5 OUT 2 indicator
6 EV 1, EV 2, EV 3 indicators
7 STBY indicator
8 MANU indicator
9 Lock indicator
10 No. indicator
11 RUN/HOLD/END indicators
4 5 6
13 14 15
Indicates process value. Shows parameter name when in
parameter setting. (Program Value)
Shows set point. Shows parameter set value when in
parameter setting. (Set value)
Shows screen No. when in parameter setting.
Lights during control output 1 is ON.
Lights during control output 2 is ON.
Lights during digital output 1 to 3 are ON.
Lights during standby.
Lights during manual mode.
Lights during key lock.
Lights during indicating screen No.
Lights during ramp/soak operation.
ENGLISH
7 8
16
17
2
1