Troubleshooting - Dometic MagicWatch WPS 900F Manual Del Usuario

WPS900F/WPS910
11

Troubleshooting

The device shows no function.
The cables to the reversing light are not connected or are not properly connected.
The plugs for the sensors are not connected or are not correctly plugged into the
control electronics.
➤ Check the plugs and make sure they lock into place.
The speaker emits a double alarm tone, and the red LED in the control unit
and the LED on the external button flash continuously
The system has been disconnected from the front or rear sensors. This can occur due
to interference in the frequency range. Reprogramme the control modules (see
chapter "Learning the system" on page 15).
Audible error signal is emitted for three seconds after engaging the
reverse gear, following by a sequence of tones.
One or more sensors are defective or no longer connected to the control
electronics. The LEDs in the control unit and the LED on the external button are
flashing rapidly. The sequence of tones following the continuous tone indicate
which sensor is defective:
• high tones for the front sensors
(e.g. two high tones for front sensor no. 2)
• low tones for the rear sensors
(e.g. three deep tones for front sensor no. 3)
The sensor with the shortest cable is sensor no. 1, the one with the longest cable is
sensor no. 4.
➤ Check the plugs and make sure they lock into place.
➤ Replace the defective sensor(s).
A
NOTICE!
The system does not work if one or more sensors are defective.
EN
Troubleshooting
21