Safety In The Workplace - Royal Catering RCST-9401 Manual De Instrucciones

Ocultar thumbs Ver también para RCST-9401:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 50
b)
Avoid touching earthed elements such as pipes, heaters, boilers and
refrigerators. There is an increased risk of electric shock if the earthed device
is exposed to rain, comes into direct contact with a wet surface or is operating
in a damp environment. Water getting into the device increases the risk of
damage to the device and of electric shock.
c)
Do not touch the device with wet or damp hands.
d)
Use the cable only for its designated use. Never use it to carry the device or to
pull the plug out of a socket. Keep the cable away from heat sources, oil, sharp
edges or moving parts. Damaged or tangled cables increase the risk of electric
shock.
e)
If using the device in a damp environment cannot be avoided, a residual
current device (RCD) should be applied. The use of an RCD reduces the risk of
electric shock.
f)
Do not use the device if the power cord is damaged or shows obvious signs of
wear. A damaged power cord should be replaced by a qualified electrician or
the manufacturer's service centre.
g)
ATTENTION! DANGER TO LIFE! While cleaning, never immerse the device in
water or other liquids.
2.2.

Safety in the workplace

a)
Make sure the workplace is clean and well lit. A messy or poorly lit workplace
may lead to accidents. Try to think ahead, observe what is going on and use
common sense when working with the device.
b)
Do not use the device in a potentially explosive environment, for example in
the presence of flammable liquids, gases or dust. The device generates sparks
which may ignite dust or fumes.
c)
If you discover damage or irregular operation, immediately switch the device
off and report it to a supervisor without delay.
d)
If you are unsure about whether the product is operating correctly or if you
find damage, please contact the manufacturer's service centre.
e)
Only the manufacturer's service point may repair the device. Do not attempt
any repairs independently!
f)
In case of fire, use a powder or carbon dioxide (CO2) fire extinguisher (one
intended for use on live electrical devices) to put it out.
g)
Please keep this manual available for future reference. If this device is passed
on to a third party, the manual must be passed on with it.
Remember! When using the device, protect children and other bystanders.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Rcst-9403Rcst-9404Rcst-9405Rcst-9407

Tabla de contenido