Husky CUT20P Guía De Uso Y Cuidado página 11

Troubleshooting (continued)
Problem
Poor cut quality.
Excessive slag or dross.
Unstable cutting arc.
Possible Cause
□
Improper operation.
□
Worn or damaged plasma
torch parts.
□
Moisture or oil in air supply.
□
Too low cutting current.
□
Improper cutting speed (too
low or too fast).
□
Plasma torch parts are worn
out.
□
Inferior or unmatched parts.
□
Poor ground clamp or
plasma torch connection.
□ Too low input power.
□
Plasma torch parts are worn
out.
□
Too low cutting speed.
□
Please read the user manual and ensure proper use of
plasma torch and machine.
□ Check consumables for wear and replace worn parts.
□
Examine your air compressor and make sure it is in a good
working condition.
□
Install a moisture lter at the inlet of the machine's air
supply line.
□
Make sure your power source provides enough amperage
or reduce the length of your extension cord.
□
For excessive top slag/dross, decrease your cutting
speed.
□
For excessive bottom slag/dross, increase your cutting
speed.
□
Check consumables for wear and replace worn parts.
□
Use genuine manufacturer parts for optimum performance.
□
Check connection of ground cable or plasma torch and
make sure they are well connected.
□
Make sure your power source provides enough amperage
or reduce the length of your extension cord.
□
Check consumables for wear and replace worn parts.
□
Increase your torch travel speed.
11
Please contact 1-888-43-HUSKY for further assistance.
Solution
HUSKYTOOLS.COM