Maintenance - Husky CUT20P Guía De Uso Y Cuidado

Maintenance

□
Before each use, inspect the general condition of the machine. Check for loose screws, cracked or broken parts, damaged circuit
wiring or cables, and any other potential risks that may cause safety issues.
□ After each use of the machine, clean external surfaces of the machine with clean cloth.
□
Periodically clean the machine using compressed air to blow out all dust and debris from the interior.
□
If retaining cup is cracked, burned through, chipped or no longer round, replace it before operating the plasma torch.
□
If the cutting tip orifice becomes damaged or enlarged, replace it before operating the plasma torch.
□
If electrode's emitting surface is pitted more than 1/16 in., replace it before operating the plasma torch.
□
If the unit continuously shuts down due to thermal overload, please turn off the machine and have a qualified electrician to inspect
the machine and repair it.
□
If consumable parts' exteriors are oxidized, use an extra-fine abrasive cloth to clean.
□
Store the machine and accessories in a clean and dry location out reach of children.
9
Please contact 1-888-43-HUSKY for further assistance.
HUSKYTOOLS.COM