Wisor Working Mode - mamibot EXVAC880 Wisor Manual Del Usuario

Wisor Working Mode

Auto Cleaning
The Laser of Wisor will detect a part of the room first, then plan and
clean the detected room in "Zigzag" path. After the detected area
cleaning finished, Wisor will detect another new areas for next plan
until the whole room cleaning is finished. Wisor can work under Auto
cleaning mode through the Start/Stop button on Wisor, or the Auto
cleaning button on the remote control, or the Start button on the App.
Turbo Mode
Press the button at the Auto Cleaning mode to enter the Turbo
Cleaning mode. Users can also adjust the suction power via APP, there
are three levels including: Silence, Standard and Strong suction.
Mopping Mode
To enter the Mopping mode with water tank attached to the robot,
Wisor will work as the path in Auto Cleaning mode. There are three
levels of water dripping speed: low,medium and high.
Not-to go Area Setting
To set the area which users'do not want Wisor to enter by the
APP, it is similar to the function of a virtual wall.
Spot Cleaning
Press this button to enter Spot cleaning mode.
Positon
Press the Position button on the APP, Wisor will say "I am here", it would
be useful for finding Wisor if it is stuck.
Notice:
The main power switch of Wisor should be kept on.
The remaining battery of Wisor is more than 5%.
The voice of the WIOSR is switched on.
14