mamibot EXVAC880 Wisor Manual Del Usuario página 23

Wi-Fi Setup Requirements
Before Wi-Fi setup, please make sure that Wisor and your Wi-Fi network
meet the following requirements.
1. The Wi-Fi Network you are using is 2.4 GHz router or a dual-band router.
Wisor does not support 5GHz frequency band.
2. The Wi-Fi network you are using supports 802.11b/g/n and IPv4 protocol.
3. Please make sure that there is no illegal character in your SSID, or the Wi-
Fi may not be recognized.
4. Please don't use a virtual Private Network (VPN) for connection.
5. Please make sure that your password is correct when entering.
6. Please make sure Wisor is fully charged or on the dock station, and the
main power switch on the side of Wisor is turned on.
7. Please make sure that you hear the voice of prompt for connection,
and the Wi-Fi status light slowly flashes white.
8. Please make sure that your Wisor, Router and Smartphone are as close
as possible.
APP Connecting
1. App downloading
Scan the below QR code (Fig.2) of Weback app (Fig.1), or down load the
Weback app from the App Store (IOS devices) or Google Play (Android
devices).
weback
2. Log in/Register weback ID.
Open the app, log in with your weback ID directly, or follow the instructions
and creat a new user ID, then log in and enter weback interface.
3. Connect the Wisor to the App.
Tap the " " icon and enter the interface as Fig.8 to add Wisor to your we-
back ID: Scan the following QR code (Fig.9) of Wisor or from bottom shell
of Wisor or manual input the number of "exvac-880-"(Fig.10) to enter the
interface as (Fig.11). Choosing your WIFI and enter password of the WIFI,
then confirm as Fig.12. and Fig.13.
Fig.1
21
Fig.2
Google Play
IOS