Terraillon POWER STEPPER Manual De Instrucciones página 22

BODY STIMULATION ( )
ADAPTER
DC 6V/0.3A
22
POWER STEPPER - INSTRUCTION MANUAL
Step 5 - Start treatment and adjust intensity
• Using either the remote controller or buttons on the device to set the intensity level
The treatment will begin and the [
treatment.
CAUTION:
• We recommend using a heel balm on your feet to improve conductivity and stimulation.
• Each person may require a different intensity level to obtain the optimal muscle stimulation. The
device can safely be used on intensity level 1 to maximum level 99.
• There are 15 therapeutic modes working as a cycle. 15 therapeutic modes will work alternately,
every 1 minute it will change a mode.
• When use POWER STEPPER, the footboard will effortlessly tilt back and forth as per your feet
rocking motion.
• If you remove your foot from foot pads, the device will give three short "Beep" sound (if intensity
> 10). Intensity of stimulation will come down to 10.
• Once put your feet back to the foot pads, the intensity level will be increased slowly to the level
you set.
• During this period, the display shows the intensity level you set and no change immediately.
Step 6 - Turn OFF the device
• Press the power button [ ] on the device or hold 2s the ON/OFF button on remote control.
• If the device stop treatment (Intensity = 0), the device will be turned off automatically after
2 minutes.
• If the remote control is disconnected with the device, the remote control will be turned off
automatically after 1 minute.
Step 1- Attach pads to the cables
• Take the pads out of the sealed package.
• Insert the clip of the cable to the electrode pads.
• Make sure the end caps are fully inserted to the end.
Step 2 – Connect the electrodes to the device.
• Insert the other end of the electrode power cable into the socket on the back of Power Stepper.
CAUTION:
Ensure that your device is turned OFF.
EN
] display start counting down the remaining minutes of
[ ]