Setup For Ipod; Ipod Compatibility; Information On The Connections And Functions; Radio - Pioneer MVH-AV285BT Manual De Instrucciones

Setup for iPod

When using an iPod with this product, configure the settings of
this product according to the device to be connected.

iPod compatibility

This product supports only the following iPod models and iPod
software versions. Others may not work correctly.
 iPhone 4, 4s, 5, 5c, 5s, 6, 6 Plus: iOS 7.0 or later.

iPhone 3GS: iOS 6.0.1
 iPod touch (4th, 5th generation): iOS 6.0.1
 iPod touch (3rd generation): iOS 5.1.1
 iPod touch (2nd generation): iOS 4.2.1
 iPod classic 160GB (2009): Ver. 2.0.4

iPod classic 160GB (2008): Ver. 2.0.1

iPod classic 80GB: Ver. 1.1.2
 iPod nano (7th generation)
 iPod nano (6th generation): Ver. 1.2
 iPod nano (5th generation): Ver. 1.0.2
 iPod nano (4th generation): Ver. 1.0.4

iPod nano (3rd generation): Ver. 1.1.3
p You can connect and control an iPod compatible with this
product by using separately sold connector cables.
p Operation methods may vary depending on the iPod model
and the software version.
p Depending on the software version of the iPod, it may not be
compatible with this product.
For details about iPod compatibility with this product, refer
to the information on our website.
This manual applies to the following iPod models.
iPod with 30-pin connector
 iPhone 3GS, 4, 4s

iPod touch 2nd, 3rd, 4th generation

iPod classic 80GB, 160GB
 iPod nano 3rd, 4th, 5th, 6th generation
iPod with Lightning connector
 iPhone 6, 6 Plus
 iPhone 5, 5s, 5c

iPod touch 5th generation

iPod nano 7th generation
Information on the connections
and functions
The settings and cables required for connecting each device,
and the available sources are as follows.
iPod / iPhone with a 30-pin connector
When connecting via CD-IU201V (sold
separately)
 Available sources
iPod (audio)
iPod (video)
iPod / iPhone with a Lightning
connector
When connecting via CD-IU52 (sold
separately)

Available sources
iPod (audio)

Radio

Displays the preset channel list.
Select an item on the list ("1" to "6")
to switch to the preset channel.
Selects the FM1, FM2, FM3
or AM band.
Radio
21 48
1
6/10
2
FM1 AM
Abcdefghi
3
Abcdefghi
4
Abcdefghi
5
000.00
6
MHz
Performs manual tuning.
Performs seek tuning or
HOLD
non stop seek tuning.
Releasing the key in a few seconds, skips
to the nearest station from the current
frequency. If you touch again while the
system is searching, cancels seek tuning
and performs manual tuning.
Keeping holding the key for a long
seconds, performs non stop seek tuning.
Recalls the preset channel
stored to a key from memory.
Stores the current broadcast
HOLD
frequency to a key.
Searches for a broadcast by PTY information.
 Searching by PTY information on page 12
p By pressing or , you can also switch the preset
channels.
p By pressing and hold or and release, you can
also perform seek tuning.
11