Cleaning Pads - Hilti HA EXO-O1 Manual De Instrucciones Original

To help ensure safe and reliable operation, use only genuine Hilti spare parts and consumables. Spare
parts, consumables and accessories approved by Hilti for use with the product can be found at your
local Hilti Store or online at: www.hilti.group.
8.1

Cleaning pads

1. Remove the pads from the arm supports and the waist belt.
2. Hand-wash the pads in water with pH-neutral soap.
3. Thoroughly rinse the pads.
4. Allow the pads to air-dry.
5. Reinstall the pads.
8.2 Replacing pads
1. Remove first the inner pad and then the outer pad
from each arm support. The pads are held in place
in the arm supports by burr fasteners.
2. Install the new pads in reverse sequence in each arm
support. Make sure that the pads are fitted right way
round.
The pads and the arm supports are color-
coded, with a blue dot for left and a red dot for
right.
3. Open the burr fasteners of the waist belt pad and
remove the pad.
4. Pass the burr fasteners of the new pad though the
openings in the belt web and close the fasteners.
*2282599*
2282599 English 41