Transport And Storage - Hilti HA EXO-O1 Manual De Instrucciones Original

7. Pass the strap through the second tab from the inside
to the outside.
8. Close the strap at the burr fastener.
8.4 Checking and cleaning ball socket
▶ Check the movement of the ball end in the ball socket.
Do this by moving the threaded rod.
Result 1 / 2
The ball moves freely.
▶ No action necessary.
Result 2 / 2
The ball is stiff
▶ Undo the two screws in the ball socket and
remove the cover.
▶ Remove the ball from the ball socket and clean
the ball and the socket with a soft cloth.
▶ Reinsert the ball in the ball socket and place the
cover in position.
▶ Tighten the two screws to a tightening torque of
0.5 Nm.
9

Transport and storage

Transport
▶ Make sure that the equipment is held securely throughout all transport operations.
▶ After transporting, always check all visible parts and controls for signs of damage and make sure that
they all function correctly.
▶ Transport and store the exoskeleton only with the expanders at zero tension.
Storage
▶ Store this product in a dry place, where it cannot be accessed by children or unauthorized persons.
▶ After a long period of storage, always check all visible parts and controls for signs of damage and make
sure that they all function correctly.
10 Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem by
yourself, please contact Hilti Service.
Trouble or fault
Lack of expander tension
Articulation unit sticks
Pads chafe
*2282599*
Possible cause
Expander disengaged or incor-
rectly installed
Expander worn
Articulation unit worn
Pads dirty
Pads folded over or worn out
2282599
Action to be taken
▶ Check that the expanders are
correctly seated. → page 31
▶ Contact Hilti Service.
▶ Contact Hilti Service.
▶ Clean the pads. → page 41
▶ Contact Hilti Service.
English 43