Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
8.3
Replacing arm-support strap
1. Open the burr fasteners at both ends of the arm-
support strap.
2. Remove the strap from the two tabs of the arm
support.
3. Position the top part of the magnetic catch at the
parked position on the arm support.
4. Starting from below, pass the new strap through the
first tab. The burr fastener must face out.
5. Turn the arm support round.
6. Pass the strap from above through the metal eye of
the magnetic catch.
42
English
2282599
*2282599*
Publicidad
Tabla de contenido
