Publicidad
CHARGING AND USE
•The IDX-100 is shipped factory set at the specified intensity for optimal
performance during inspections.
•Turn flashlight upside down, unscrew and remove tail cap from housing and place
included Li-Ion battery positive end towards head of flashlight. Attach provided
lanyard to tail cap.
•Replace tail cap by screwing into flashlight housing.
•At
USD Type-C cable into flashlight and opposite end into provided 5V Power Adapter.
•The flashlight's charging indicator light displays red when charging and green
when fully charged. Disconnect flashlight from USB Type C cable when charging is
complete.
•The IDX-100 has one switch (on and off) on rear of tail cap. Prior to using the
flashlight, ensure that the switch is in the off position (no light illuminating from the
flashlight).
Instant-on
intensity immediately. Check to see if the unit is operating optimally.
•Press switch again to turn the flashlight off.
UV INTENSITY VERIFICATION
To ensure that your IDX-100 flashlight is operating at the required
UV intensity, it should be checked periodically. The AccuMAX ™ XRP-3000
radiometer/photometer kit uses a UV-A sensor detector to accurately measure
ultraviolet irradiance. For more information about these units, please contact the
Customer Service Department at Spectro-UV. Call toll-free 1-866-230-7305.
CARE AND USE OF LITHIUM-ION (Li-ion) BATTERIES
•Do not allow Li-ion batteries to fully discharge frequently, since this will put
a strain on the batteries. They will work more efficiently on multiple partial
discharges through regular use (every 2-3 weeks), and frequent recharges.
•When not in use remove the batteries from the flashlight and store separately.
•Before prolonged storage (30 days or more), charge the battery for at least two hours.
•Store batteries in a cool environment away from sunlight, heat and humidity. Store
the battery at temperatures between 5 °C and 20 °C (41 °F and 68 °F).
•The battery self-discharges during storage. Higher temperatures (above 20 °C or
68 °F) will reduce the battery storage life.
•Li-Ion batteries are subject to disposal and recycling regulations that vary by
country and region. Always check and follow your applicable regulations before
disposing of any battery.
CARE AND MAINTENANCE OF FLASHLIGHT
•It is suggested to regularly replace or lubricate the included O-ring and screw
thread to ensure seal and smooth tail cap removal and replacement.
•Turn
filter glass. Please use lens
•For long term storage remove battery from flashlight.
•Be sure to use genuine Nano 365 Series replacement parts. Using another
manufacturer's parts could affect product performance and will void
the lamp's warranty.
WARRANTY
The
Certificate of Limited Warranty enclosed separately with each unit. The part
number and serial number for the flashlight is located below the lamp head opposite
the USB C charging port.
1.800.544.2843
center
of
flashlight
is
The indicator light flashes when power is below 20% capacity.
Press
the
switch
operation
ensures
off
flashlight
and
warranty
policy
for
www.calcert.com
15
10
20
5
25
0
30
USB-C
charging
port,
once
to
turn
the
that
the
UV-A
LED
ensure
unit
is
cool
tissue, or non-dust cloth for cleaning.
the
IDX-100
is
connect
provided
flashlight
on.
will
reach
full
before
cleaing
provided
on
the
sales@calcert.com
Publicidad
