Krups XP3410 Manual Del Usuario página 27

5. Plug the appliance in (1).
6. Press the on/off switch (5).
7. When the temperature light on the on/off switch stays on (6), press and hold the
Espresso button (D2) for 40 to 50 seconds (water will flow through the filter holder) (9).
8. Empty and replace the container if necessary.
9. Wait 5 to 10 minutes, then repeat the procedure twice.
10. Ensure that you do not empty the tank completely (in the case of deactivation, see
paragraph: USING FOR THE FIRST TIME).
B. Rinsing
IMPORTANT!
After descaling, rinse two or three times with clean water (without coffee),
as described in the paragraph on "USING FOR THE FIRST TIME".
The appliance has been descaled and is ready to use again.
Your appliance is guaranteed, however, any connection or handling error, or use other
that that described in the instructions will render the guarantee void.
This appliance is guaranteed for domestic use only, any other type of use will render
the guarantee void.
No repairs due to a build-up of limescale shall be covered by the guarantee.
For any after-sales problem or for spare parts, please contact your retailer or an
approved service centre.
SOLUTIONS TO POSSIBLE PROBLEMS
PROBLEMS
The grounds are
damp.
The espresso
through too slowly.
GUARANTEE
POSSIBLE CAUSES
very You haven't added enough
ground coffee.
flows The ground coffee is too
fine, too greasy or floury.
The filter holder is dirty.
The grid through which the
water passes is clogged.
Your appliance has a build-
up of limescale.
SOLUTIONS
Add more coffee.
Choose a slightly more
granular coffee.
Clean the filter
according to
instructions in paragraph
CLEANING
SERVICING ‑ B. The filter
holder. Clean also the
coffee filter.
When the appliance has
cooled, clean the grid with
a damp sponge.
Descale your machine
according to the instructions
in the user manual.
holder
the
AND
25