Krups XP3410 Manual Del Usuario página 28

PROBLEMS
The user sees prolonged
water flow from the filter
holder after making an
espresso.
Presence of coffee grounds
in the cup.
No crema on the espresso. The coffee is too old.
The water tank leaks when
carried.
Water is leaking under the
appliance.
The pump is abnormally
hot.
26
POSSIBLE CAUSES
Scale build-up is occurring
on your machine because
of particularly hard water.
The filter holder is clogged. Clean the filter holder with
The coffee is too fine.
The hinge on which the
filter holder is mounted is
clogged.
The coffee is not suitable
for espresso.
There is too little coffee in
the filter.
The valve at the bottom
of the tank is dirty or
defective.
The valve is blocked by
limescale.
There's an internal leak.
The drip tray has not been
fitted correctly.
The drip tray is overflowing. Empty and carefully rinse
There is no water in the
tank.
SOLUTIONS
Immediately
your machine as per the
directions for use.
hot water.
Use a slightly
granular coffee.
Clean the filter
mount and hinge with a
damp sponge.
Use freshly ground coffee.
Use finer ground coffee.
Add ground coffee.
Clean the water tank and
open the valve at the
bottom of the tank with a
finger.
Descale your
according to
instructions in the user
manual.
Check that the tank is
fitted correctly. If the leak
continues, do not use
the appliance, contact an
approved service centre.
Check that the drip tray is
pushed to the back of the
appliance.
the drip tray and replace.
Fill the tank with water
and re-initiate the pump
(see paragraph: USING
FOR THE FIRST TIME).
Avoid emptying the tank
completely.
descale
more
holder
machine
the